Manley Neo-Classic 300B Owner's Manual

THE NEO-CLASSIC 300B PREAMPLIFIER RCOWNER’S MANUAL TUBES RULE rev4.20.11cd

REMORA REMOTE CONTROLOPERATING INSTRUCTIONSQuick Start:Your Remora Remote Control system has been congured and tested at the factory to verify that t

Remora Remote Features!1. Remote transmitter and receiver operate under crystal-clocked microprocessor control for maximum signal discrimination, exi

The Remora system is highly resistant to false operation due to noise or other remote signals, but the range will be reduced if the competing signals

How to change the user-numbers and re-pair the system:Ordinarily there will seldom be a need to change the user-number. Changing the user-number requi

SPECIFICATIONS * Inputs: 5 stereo pair unbalanced RCA jacks * Outputs: 2 stereo pairs MAIN out same as SUB out unbalanced RCA jacks * RECORD output: 1

CONTENTS SECTION PAGE INTRODUCTION & GENERAL NOTES 3 MAINS CONNECTIONS 4 CONNECTING YOUR PREAMPLIFIER 5 FIGURE 1 FRONT PANEL 6 FIGURE 2

INTRODUCTION THANK YOU!... for choosing the Manley Laboratories 300B Preamplier RC. Handcrafted in Chino, CA, the Neo-Classic 300B Pre-amplier RC

4 MAINS CONNECTIONS Your Neo-Classic 300B Preamplier RC has been factory set to the correct mains voltage for your country. The voltage setting is

CONNECTING YOUR PREAMPLIFIER Setting up your preamplifier is rather easy. 1. Please refer to page 8 for an illustration of the back of the preamplif

FRONT PANEL AUX TAPE CD TUNER VIDEO HEADPHONES VOLUMEA B C D E

TOP VIEW OD3OD3A5U4G 5U4G 300B 300B 6SL7GT 6SL7GT A) HEADPHONE IMPEDANCE SWITCH - You should set this switch to best match your headphones. Yo

A B REAR PANEL CDEH F G J A) MAINS FUSE - Depending on your local power outlet’s voltage, replace with 3A SLO- BLO fuse (120 V) or 1.5A SLO-BLO

OPERATIONAL NOTES SWITCHING ON The power knob is located on the right hand side of the front panel. Turn the knob to the right to turn on the preamp